JAMES H. MOON RT – NPI #1861597569
Radiologic Technologist

A radiologic technologist who specializes in radiography (also known as x-rays) and is appropriately educated and trained, consistent with nationally recognized standards, state statute, and facility policy in performance of radiographs, exam techniques, equipment protocols, radiation safety, and patient care.

JAMES MOON is a radiologic technologist located in GREENVILLE, SC. NPPES has assigned the NPI number 1861597569 to JAMES MOON on September 14, 2006. It is a Type-1 NPI, indicating this NPI number is associated with an individual. The primary taxonomy selected by this provider is 2471C3402X from the Health Care Provider Taxonomy code set, which is classified as Radiologic Technologist, specializing in Radiography Radiologic Technologist

The NPI profile was previously updated about 19 years ago on Jul 08, 2007. Use the NPI data found here to bill health insurance companies, identify providers enrolled in Medicare and Medicaid services or other HIPAA compliant transactions. See the complete NPI profile for JAMES MOON below.

NPI Profile for
JAMES H. MOON

NPI Number
1861597569
Enumeration Date

(about 20 years ago)
Entity Type
Type-1  Individual (Male)
Legal Name
JAMES H. MOON
Credentials
RT
Primary location
210 W STONE AVE
GREENVILLE, SC 29609-5452
Phone: (678) 654-1560 Fax:
Mailing address
PO BOX 1718
CARTERSVILLE, GA 30120-1679
Phone: (678) 654-1560 Fax:
Sole Proprietor
Yes
Updated
Taxonomy Code(s)

A taxonomy code is a code that describes the health care service provider's type, classification, and the area of specialization. The primary specialty for this provider is indicated as (Primary) below.

Taxonomy Classification / Specialization State License
2471C3402X
- Radiologic Technologist / Radiography Radiologic Technologist (Primary)
SC SCRQSA#00-8504

The taxonomy codes are selected by the provider at the time of NPI registration. Selection of a taxonomy code does not replace any credentialing or validation process that the provider requesting the code should complete.